Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Personal Drone Repair

  1. Personal Drone Repair

    Typhoon H Flight Controller Failure.

    Thank you so much for the feed and direction! Class Act!
  2. Personal Drone Repair

    Typhoon H Flight Controller Failure.

    Thank you for the response. I understand your logic. I have cleaned and calibrated the ST16. I have taken note in the hardware monitor, of the ST16, that the controls are all holding zero value at center point with no drift. Believe me, I wish that were the problem. Already going bald as it...
  3. Personal Drone Repair

    Typhoon H Flight Controller Failure.

    The yawing is in the GUI. When powered up outside, GPS stays in the acquiring state. Due to this, I tested the gps battery voltage. 2.4volts ST16 shows 16-18 satelites. Aircraft shows 10-12. I have powered up the controller and aircraft and allowed the unit to sit outside for over 30 minutes...
  4. Personal Drone Repair

    Typhoon H Flight Controller Failure.

    While calibrating the accelerometer of the Typhoon H, I cannot get past the white led in the rear. I am calibrating on a wooden, level surface. I was able to get through the process prior to a firmware update. Formatted the sd card, copied the .bin file, inserted the sd card into the camera and...
  5. Personal Drone Repair

    Typhoon H GUI Compass Values

    I have a Typhoon H that has been placed near a large magnet. I have performed the calibration and by all of Yuneec's led communication, the calibration was a success. Call me OCD, I would love to know the proper compass value readings. I am looking to connect to the Yuneec GUI and verify the...
  6. Personal Drone Repair

    Binding ST16 To H920

    Thank you to all of you. Just to help any one else that may run across this thread, yes. I was able to bind the ST16 to an H920 (non plus) The binding went text book. Calibrated all endpoints, checked them in Hardware monitor. Success!! All motors responded with authority. This is quite an...
  7. Personal Drone Repair

    Binding ST16 To H920

    Some one recently inquired if they can bind an St16 Controller to an H920. I have 0 experience with this particular model. This may be a dumb question to you guys but I just do not know the answer. I took a look in the search section and I did not come across the answer. Can the ST16...
  8. Personal Drone Repair

    Typhoon H Remote Payload Drop Device

    Some one recently questioned me regarding a remote payload drop device for the Typhoon H. The real question here is what does this individual plan on dropping? ? I personally have no knowledge of this and could not give this individual a good answer. Does any one know of a remote payload drop...
  9. Personal Drone Repair

    CGOET thermal imaging and low-light camera

    Thank you for the reply and the thank you for this information.
  10. Personal Drone Repair

    CGOET thermal imaging and low-light camera

    I need some real world input from pilots that are using this camera on a Typhoon H3. I have a customer that is interested in an infrared set up for his Typhoon H3. I have no experience with this set up and I have no desire to mislead my customer. Any input will be much appreciated . Thank You
  11. Personal Drone Repair

    Typhoon H Camera Slide

    Thank you for the reply. I have located the camera base on ebay. 3D printed but my fingers are crossed. Thank you again for the reply.
  12. Personal Drone Repair

    Typhoon H Camera Slide

    Awesome tip !! Thank you for the heads up !!
  13. Personal Drone Repair

    Typhoon H Camera Slide

    Does any one here have the camera slide for a Typhoon H that they would be willing to part with? Thank You
  14. Personal Drone Repair

    Electronics Repair - Soldering Guide

    Apologies for the late reply . This story got out of hand quick . I will sum it up by saying " that I would not order free toilet paper from Banggood.com if I only had corn cobs to wipe with " . Miserable experience . 8 weeks and no soldering station . Canceled the order from Banggood.com . 2...