Recent content by Phillip Q

The monitor for the T-16 has a bad glare to it no matter if I have a shield or not. I would like to connect my T-16 to my much larger lap top screen. Any ideas how to do that? I hook the hdmi cable to it but it did not work.

Yup. I replaced the camera because the H started to drift and crashed in to a tree all on its own. I am thinking a wire inside may have broken loose or a connection got loose. I replace the camera and the mount. I sent a message to Yuneec and they said it was covered but that was last week and...

Pins are good.

Ok, did all that twice. The camera still does not move.

I also have a damaged CG03+ I need to send in for repairs. Do you know who I can send to in California?

Clear what data. All the data on the sims card?

Yes I did. However I did that before I updated the software. Should I bind it again?

I bought a new CGO3+ camera for my Typhoon H Pro. I downloaded updated software, and connected everything. I get a picture but the camera will not move or rotate in any direction. Is it a loose wire or a software issue.

I would like to see a "trouble shooting section". Example. My Gimbel CG03+ will not rotate or move? Then a check sheet for possible solutions.

I have my cell phone on, the compass was calibrated. It was in my home court. When I got the H I use it in an open field. When I go the pro it was only used in my street court for a few seconds. The H worked fine in the court for awhile. The pro does seem to follow my controls at all.

Does anyone lese have an issue with the Typhoon H or Pro drifting on its own. Mine crashed and I had no control over the unit. Is this a firmware issue?

I had a hard landing. After that when I fly left or right and then go to hover mode it keeps flying left or right. It flys forward just fine. Also when I switch to home mode it flys straight up very fast.

Where can I send my Typhoon H for repairs? I am in California.