Recent content by pjf

Possibly intermittent battery installation problems/connections..???

The "manual"..?? LOL! If you aren't into You Tube or this site and won't do the research necessary to be successful, you'll be like all the other "I want it for free and have it done for me because I'm too lazy to do the homework" failures that permeate our society.. Good luck, you'll need...

I don't believe such a thing is possible unless the other ST16 and your drone have somehow bound together (paired - binding process) without your knowledge or assistance.. Frankly, I'm more worried about 2-legged animals trying to pry it away from me, but they would be met with "destructive...

No battery suggestions. As far as the camera is concerned, are all four corners secure in their rubber bushings? I've installed the other two plastic retainers after a semi-hard landing & one of the bushings pulled loose... Take a look, you've got nothing to lose.

After one of the rubber dampers dislodged, I found that the H has only two retaining pins... Since then I have added the remaining two, one for each corner attachment. Of course, that won't prevent something from ripping the camera loose from it's moorings.. LOL! Quite frankly, I believe the...

"Well, WD40 (contact cleaner) still works wonders on certain bits of my motorbike"... Oh yes,

WD40????? LOL! A definite No NO for electronic work... LOL!

And try and return them to the approximate 1/2 way position you started with before moving on..

Blown fuses are a SYMPTOM & RESULT of a problem in the circuit...

Does the camera work????? LOL!

If you didn't know how far out you were, did you 'GUESS' at the 3000 ft.???

"proves anything" Maybe not to you!!!! I'm not telling anyone NOT to buy this, only describing my situation. That being said, then this forum should close down because it's primarily here to share advice for either user error or misinformation, or MANUFACTURER ERROR!!!! As in defective product...

I've done the same, but the #2 bay is still dead. At least the other 3 are working (so far). But for the $229 this costs, there should be better quality control. For Venom to just send another out (although I didn't receive it......yet) to replace what I have, proves that this a 'throw-away...

Received mine the beginning of July. It worked fine 3 times. On the 4th time, bay # 2 did not turn from green to red when a battery was inserted. I checked to be sure this was the same result w/other batteries. (Also noticed that the batteries need to be pushed into the bays w/some resolve or...

Maybe you could ask Yuneec directly & report back w/the correct answer to your question???