Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by presman30

  1. P

    Large Tarot x6 960 build

    Got it. All makes sense. Was just wondering for cost I figured I could get a wrecked typhoon and strip it and use electronics and remote. Very new to builds so have a lot of research to do for what I need to make this monster setup
  2. P

    Large Tarot x6 960 build

    Would it be possible to use the main board and GPS and remote for a large build for my Tarot x6 960 build? I love the Typhoon H platform and would love to have that for my build on a larger drone. Had a Typhoon H while back. Any advice or tips are appreciated it! And if you have parts lmk! Thanks!
  3. P

    Yuneec Typhoon H

    Bump. Looking for offers need to get rid of asap
  4. P

    ****Need these parts****

    I think I am still missing the cap in image 2
  5. P

    Yuneec Typhoon H

    This is a project I have been working on. This drone flies and works fine but the camera is what needs to be worked with so I am selling the camera as parts. I have everything for the camera I just can't figure out all of where the wiring goes and how it runs. The camera cuts on and has a live...
  6. P

    CG03+ camera

    Which one is the roll encoder?
  7. P

    CG03+ camera

    Now I have a long beep, long beep, short beep, short beep
  8. P

    CG03+ camera

    I've checked it. All the joints appear to be fine and it is plugged in correctly. The tilt pitch encoder is supposed to be plugged in on the left side in the middle right?
  9. P

    CG03+ camera

    Sorry for late response. Okay so check the tilt pitch encoder first
  10. P

    CG03+ camera

    Normal beep, normal beep, short beep
  11. P

    Landing gear assembly

    I see that. It would only be about 10 bucks here. From there it would have obviously been about $30 US dollars
  12. P

    CG03+ camera

    I have a video signal but the camera isn't calibrating and moving into position properly
  13. P

    CG03+ camera

    Okay so I plugged it in and the light goes yellow. The camera starts to move but sits at an awkward angle. Then 3 beeps
  14. P

    CG03+ camera

    Your never going to believe this but when I ordered the frame for the camera they sent me one of these on accident. Is this the correct part and board?
  15. P

    CG03+ camera

    I dont have that sensor. That's what I'm missing. I should still be able to figure out if that's the right piece though