Recent content by Rapidroy

well the more i connect and disconnect the wifi it is taking less time to get the front leg red then green ,4 - 5 on and off cycles of the power button gets it.

I mentioned the "bricked" because i knew someone would say i bricked the motherboard. do you have a schematic for the boards. what do you mean by thermal issues. maybe it needs new thermal paste, I didnt see any when i took it apart but it does have some kind of (i guess) thermal tape on the A9...

This is where it stays white 95% of the time if it turns red (in the arm) then i know i'm good to go, it turns green (in the arm) i go out and fly. I just came in from a flight but changing batterys and getting the light to go red then green might take sometime. theres got to be a bad cap or...

been there done that no difference. sometimes i get a red light in the arm then no problem to connect and fly other times it the light in the arm stays white. i do get a second beep after about 10 sec from turning on.

Well i got it to connect and fly but its like pulling teeth. Iphone 7 bluetooth controller drone flashes from the "start button" starts white, red then green then flashes blue the front arm solid white if it turns red i can see it show up on my phone wifi and connect it turns green then it flys...

hi all so now my breeze shows a white light in the leg when turned on. I did get red once today then it turned green when i paired it, i flew it just for a minute because of low battery so i landed. charged the battery now NO RED LIGHT just white. it only pairs when a red light is shown in leg...

bummer

Hi All is there a way to use G3 controller to link up with a drone software to practice with.

very good

you set your GEO fence in the software x and y = amount of ft/m up and out. for new pilots it keeps the drone close. i use iphone 6 and have never have a problem. but thats here in the USA

I got just the controller at bestbuy for 39.00 it makes flying the breeze a breeze.

hi all it would be cool if you could use the controller on a sim app of the breeze to practice. anyone know of any app's?

my son sent me this pic near San Francisco Calif.

make sure it is flat when you first turn the breeze on and it is binding to the phone. Ive seen people holding the breeze, turning it on, holding it sideway to check the lights flashing then set it down. but it could also be a bug in the software.

Make sure the breeze is on a flat and level surface when binding the wifi from your phone then the drone will know which way is straight up if you are holding the drone sideways when binding then put it down when you take off it will fly off sideways thinking that is up.