Recent content by RebelRotor

Not the same issue im afraid. My camera was not involved in a crash and I replaced the ESC board and still had the issue

I finally contacted yuneeY and sentsitiins for repair. ItIcost me 130$ and had it back in a couple weeks. I was later told you could rotate the gimbal board but I didn't risk it

Yea Ive tried numerous gimbal calibrations with the same result. Its like it genuinely believes that -90 degrees is the front of the aircraft. This happens with 2 different cameras and have binded with a different remote for additional measure.

I have a Typhoon H RealSense and it has the CGO3+ on board. The camera was working fine before I took it off, and though it sat for a while, it should still work. I get a picture and can take video, camera tracks, etc but is not as responsive as it used to be and starts up facing the left...

yes, the connector board worked on my known good TH

And yes, we got 12v from the aircraft to the gimbal connector board (6pin) though I tested it and works fine. So the issue seems to be no signal...

No, there is no power or activity with the camera/gimabl. dead as a door knob

Thanks for the reply. The ferrite core was still attached so no problems there... I traced the cable to the main board and there is no burnt smell or any signs for any electrical damage... See pic

Yes, everything works visa versa... It does seem to be something with the TH, I just can't imagine what it would be. I'm pretty good technically, so I'm not afraid to open it up...

I crashed my Typhoon H and after replacing my arm, I noticed my camera wouldnt turn on anymore. I attached my friends CGO3+ camera and it didnt work either so I figured it was the camera. I installed my CGO3+ onto his H and it worked! So, for process of elimination, I took off my 6 pin...