Recent content by rlcheek

I found my problem! I was checking the continuity on the connection cable from the gimbal to the copter, and while I had good continuity on all three wires, two of the three contacts in the copter end were not seated in the plug - a little pull on wires and the contacts slid right out of the...

There are contacts (3) on the top of the gimbal that make contact with the Typhoon when it is attached, and there is cable from the gimbal the plugs into a servo-like jack on the aircraft. This cable is also used on the grip when the gimbal is attached.

Yes, I operate the slider but it has no effect on the camera pitch. I have also checked the operation of slider with the hardware monitor on the ST10+. The numbers indicate that the slider is moving through the entire range.

I recently picked up a Typhoon G (Factory Re-certified) to make use of a GoPro I had and it appears that the pitch control on the gimbal does not function when attached to the quadcopter. The pitch control DOES work on the steady grip, but not on the bird. Where should I look for the problem?