Recent content by Stevenq500

I have looked at the data on the card is there an easy way to read it if i lose the Q?

Fat 32, a few different times, Origanal card was fat16 just tried it yesterday

build number st10+v01b30c ok did as you said, no luck, and i tried to move the tx folder out of the firmware folder,, No luck, then i moved the bin out of the tx folder, no luck/ it flies fine, i just dont understand why it wont recognize the file

i am doing just as the pdf says to, i may send an e-mail to yuneec, i just bought it a couple weeks ago

get up to lake of the clouds

South boundry was one of the spots we liked to hunt alot

i read not to extract, and i didnt, i have tried a couple cards and just doesnt see it

off the subject i used to hunt the Porcupine mountains, Bet you have fun flying that area you are in

yes that is the Folder name,, Inside are three files, one is a pdf file with instructions, one is labeled firmware and one is and Update.zip. Then there is TX folder with st10plus_tx_b32.bin inside

Chrome on a mac,,, st10plus_tx_b32.bin

I have ver. 31 firmware update on a sd card but the TX cant see the update when i get to the part where it says Select firmware update, The card is being recognized by the TX because it has Telemetry on it

i will post next flight,

if i am 100 ft directly above me Alt, the distance also reads 100ft

Q500 My tx telemetry distance shows that if i am 100 ft up right above me it is 100 ft distance, my bugs2 will show 0 when right above, is this normal?

I am new to the q500, i have a couple bugs 2c (force1), my question is the 2 batteries i got with the q500 have a little give puffy, a good battery should be hard right? the 2 morpilot i bought are solid this unit is going back because it was an open package and another is on the way, hoping...