Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Vaklin

  1. Vaklin

    ST12 Touchscreen self switching

    Without protection the problem still persist? If yes, the problem should be inside the unit.
  2. Vaklin

    ST12 Touchscreen self switching

    Did you cleaned the screen with some chemical solutions?
  3. Vaklin

    Unbrick Yuneec camera using AmbaUSB tool

    And the last. The bin file is probaly a linux like structure. An overall view with a hex editor can give something too.
  4. Vaklin

    Unbrick Yuneec camera using AmbaUSB tool

    Also vid/pid, some sniffed communication between the tool and the camera. The first important step is to resolve the expectations of the tool and the camera.
  5. Vaklin

    Unbrick Yuneec camera using AmbaUSB tool

    Try with ChatGPT. Explain the problem. Give the first few kB from the bin, and so on. It can disassemble them and to see what is inside and where probably should be stored. In A7/A9 processors some loader.elf is used often.
  6. Vaklin

    Unbrick Yuneec camera using AmbaUSB tool

    Try this: https://dzone.com/articles/converting-a-raw-binary-file-into-an-elfdwarf-file
  7. Vaklin

    Unbrick Yuneec camera using AmbaUSB tool

    I have a CHO4 camera, which stops on the middle of the startup sequence. The Android CGO4 says that something should be uploaded to the camera, but after that the problem still persists. Is the CGO4 in the same line, which can be maintained with the discussed tool?
  8. Vaklin

    CGO3

    Use Android , guys . ;)
  9. Vaklin

    GPS module

    They are different and not replaceable. The problem is not in this module. Probably a misalignment betwen the position, which is stored in the FC from the IMU and the current position, obtained from the GPS is the real problem. Try to do calibration.
  10. Vaklin

    Yuneec's software for gimbal calibrations

    The sensor is connected via PWM lines. Not every magnet position is allowed. @WTFDproject can explain this in deep. I'm agreed.
  11. Vaklin

    CGO-ET journey

    Don't update anything! You probably have degraded magnet. Search @h-elsner calibration tool inside the forum and use it.
  12. Vaklin

    ST 16

    To hide operator's location. Suitable for every purpose. The world is a war.
  13. Vaklin

    ST 16

    First will be wise to detach its cable from the mainboard and to see will be drone armed at all. If it works, of course with limitations about RTH and so on, this will be the best and stable decision. If not, use a simpler bird to achieve your goals.
  14. Vaklin

    St16 datasheet

    Better is to buy a "new" one. They They are cheap. What are the simptoms of the problem? Probably internal look and check will be not a solution.
  15. Vaklin

    St16 datasheet

    What is the final target?
See more