WTFDproject's latest activity
-
WTFDproject replied to the thread H520E RTK update problem.Update. I downloaded to version 2.1.22 and tried to use the normal OTA update to go the Version 2.1.53. The OTA update from the... -
WTFDproject replied to the thread H520E RTK update problem.Your screenshot shows the controller battery at 48%. The controller should be at a minimum of 50% to initiate an update. I don't...
-
Apologies, no just adding another drone to the collection and wanted the functionality, but love the retractable legs and all the...
-
WTFDproject replied to the thread E90 gimbal dead.I think the most likely thing is a deep firmware problem with the gimbal board. Or it is just damaged. It would be good to know if the...
-
WTFDproject replied to the thread E90 gimbal dead.The L1 and e90 are pretty much the same hardware. How similar is the e90 behavior to the L1 discussed in this thread? Floppy Gimbal...
-
WTFDproject replied to the thread New to me Thpoon H pro?."I was interested in getting a 360 degree to add to my AIR3 and Neo" Are you wanting to mount the CGo3+ on the AIR3 and Neo?
-
Welcome to YuneecPilots! If this kit included a C10 charger then it is most likely an H520 and not a Typhoon H Pro. The H520 would be...
-
WTFDproject replied to the thread E90 gimbal dead.Have you tried a gimbal reset? Do you have another e90, C23 or L1 available you could swap gimbal boards if needed?
-
-
I didn’t know this. U learn something new every day. The controller was 1 I sold and I told buyer it was faulty, turns out he had the...
-
WTFDproject replied to the thread Floppy Gimbal after Battery pull.Be prepared for the "Crazy Dance" when powering on with the new gimbal board. Installing boards that are not calibrated to your gimbal...
-
I'm trying to use the CGO3+ with a H920. Tilt was not possible with the PWM signal from H920 flight controller. CGO3+ is only working...
-
Thank you for your suggestions. Yeah ive tried a reset, while it does go through the reset process, it doesn't fix the issue. The small...
-
WTFDproject replied to the thread Yuneec st16s dead stick.The stick calibration was all it took. Directly after stick calibration the RC Monitor showed all four sticks in the center, but none...
-
WTFDproject replied to the thread Yuneec st16s dead stick.Did some more experimenting. I unplugged both gimbals on one of the spare controllers and tried to do a gimbal calibration with the...
-
WTFDproject replied to the thread Yuneec st16s dead stick.I tried unplugging the sticks on two spare ST16S for HPlus. The results were exactly the same between them: Two sticks (J1 and J3)...
