boot up
-
S
4th of July Update Bricked ST16S
I just started the update, and everything went fine till it was the TX turn to update. First off it said I was updating from 0.3.0 to 1.0.1 or something very close to that. Then it reboots and downloads version 0.33.0 and says that it was on version 0.0.1?? After that the screen went dark like...- Solostarian
- Thread
- boot up bricked help please reset st16s updates
- Replies: 15
- Forum: H520 Discussions
-
K
ST16 controller EFI problem
Hello, Started receiving "efi hard drive boot failed" message on the ST16's screen when powered on, and does not go away when I power off. I've had to disconnect and then reconnect the battery and then power on again for the controller to again function properly. This happens at odd intervals...- kenkojuku
- Thread
- boot up controller issue efi hard drive failure st 16
- Replies: 2
- Forum: Typhoon H Discussion
-
Firmware 3.01 screwed up H!! Help!
So, I tried to do a firmware update following the standard procedure. Now, when I power on the H I don't get the normal series of beeps and the LEDs don't come on. The camera light is green and connects to the ST-16. The H power light is on. Gimbal Version: V.125 Autopilot Version: N/A...- NoCoOutdoorGuys
- Thread
- boot up bricked firmware no leds
- Replies: 12
- Forum: Typhoon H Discussion