tilt

During the most recent flight of my Yuneec Typhoon H with CGO3+, I flew a tad too low over a roof and clipped the bottom of the camera on the top of the roof ridge. No crash, but the event force rotated the camera in the gimbal such that it was jammed 90 degrees on the roll axis, and broke the...

I took my Yuneec Typhoon Q500 4K for a fly yesterday for the first time. Everything works great. The only thing is camera was not tilting. When I was using the ST10 remote button for tilting, I could hear the beep from the remote but no tilting in the camera. I took off the camera and attached...

I want to mount the Gimbal and Camera to a camera dolly, It has power and works to stabilize. Using Pins for power. Pins labeled TX and PWN are not connected (should they be?) and I want to use an ST16 to control the pan/tilt of the gimbal. I have tried ALOT of ways, but pan and tilt ONLY work...

Hey gang, I was super excited to fly my drone in Compton today after receiving my replacement mount last night. But now that she's airborne, my pan & tilt abilities aren't working. However, once airborne, at least the fixed camera (VS slight pan to correct itself and look forward) ability is...

Has anyone had a problem with the “horizontal tilt” stop working? I have run diagnostics and controls check out but I have no movement from camera. I have tried several different cables and received the same results. I am open to any suggestions.

Hi, I have this problem with my Wizard on the Typhoon H. It works great except it seems to be unable to send tilt commands to the drone. When I'm trying to manually tilt the camera through the buttons on the Wizards it does nothing. Also, when I go in Smart Mode and Activate the Watch me Mode...

I have an issue with my Yuneec Q500+...I crashed it into a tree....a blade broke and the CGO2-camera fell off...and now to my problem: the camera ripped off from the gimbal and the connector cable was damaged... on the circuit board the connection a place for the power-supply was damaged and on...

I'm new to this forum and am struggling to find a previously posted thread with this back story but I'm further along now ( will be sure to subscribe to this one). I find the drone a bit difficult to land. I was landing on a picnic table and rolled off. Broke the Gimbal clips and I broke the...

I'm new... Is there a way to do a diagnostic on the camera? I've found this thing does not land like a helicopter. In fact, it doesn't really like landing at all... I was doing ok but then tried to land on a picnic table not thinking. It rolled off the table. I broke a few of those gimbal...