Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Reconnecting to camera….Reconnecting to camera….

Joined
Apr 12, 2017
Messages
2
Reaction score
0
Age
60
I updated the firmware and was going to do a flight shhot with my students today and it wont work.

It says Reconnecting to camera….

and it never leaves that message. I tried pairing the camera to the ST 16 and it wont.



It has 2 lights that are white, one green, one blue, and 2 that are red on the drone arms.



I have searched for answers but I am at a loss.
 
I updated the firmware and was going to do a flight shhot with my students today and it wont work.

It says Reconnecting to camera….

and it never leaves that message. I tried pairing the camera to the ST 16 and it wont.



It has 2 lights that are white, one green, one blue, and 2 that are red on the drone arms.



I have searched for answers but I am at a loss.

did you update the camera to the latest version as well?
if not, perhaps there is a software version mismatch between bird and camera....
 
Review this video to make certain you have done everything correctly.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.
 
When you try to bind, does the camera show up on the list? If so, try making a copy of a model and then bind to the copy. Did you do the "two 45 degree tilt" method to bind?
 
When you try to bind, does the camera show up on the list? If so, try making a copy of a model and then bind to the copy. Did you do the "two 45 degree tilt" method to bind?
The video above will walk through all of those steps. Deleting the FlightData is a commonly missed step, so following the video is more important than binding at this point.
 

New Posts

Members online

Forum statistics

Threads
21,355
Messages
245,986
Members
28,317
Latest member
Car20ret