Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Latest activity

  • WTFDproject
    WTFDproject replied to the thread Typhoon H not booting up.
    The images below show the failed mosfet that caused the same symptoms on a couple TH boards I've seen. I'm pretty sure the "other" power...
    • Bad Mosfett.jpg
    • FCB MOSFET.jpg
  • Pilgrim23
    Pilgrim23 replied to the thread H520 Batteries required.
    Just spoke with Leicester Drones, they have run out a while back. How much are you charging?
  • WTFDproject
    WTFDproject reacted to h-elsner's post in the thread Typhoon H not booting up with Like Like.
    This sounds like flight controller module is defect or not proper plugged in. Maybe the 5V to 3.3V converter on the flight controller...
  • Stephen1988
    Stephen1988 replied to the thread H520 Batteries required.
    Yes definitely would be worth trying to get some original ones if possible. If u can’t I can sell new gifi ones cheaper than u will find...
  • Stephen1988
    Stephen1988 replied to the thread Typhoon H not booting up.
    They can be bought from AliExpress. EBay might have one cheaper if it is faulty
    • IMG_3979.png
  • Pilgrim23
    Pilgrim23 replied to the thread H520 Batteries required.
    Yes I'm in North Yorkshire, England. 2 of the batteries seemed to expand slightly and couldn't get them ti fit into the H520's battery...
  • Stephen1988
    Hopefully the autopilot will update now when the camera is installed. It should arrive today. One thing to note about this camera is if...
  • Stephen1988
    Stephen1988 reacted to h-elsner's post in the thread Typhoon H not booting up with Like Like.
    This sounds like flight controller module is defect or not proper plugged in. Maybe the 5V to 3.3V converter on the flight controller...
  • h-elsner
    h-elsner replied to the thread Typhoon H not booting up.
    This sounds like flight controller module is defect or not proper plugged in. Maybe the 5V to 3.3V converter on the flight controller...
    • Mainboard03a.jpg
  • h-elsner
    h-elsner replied to the thread Mantis app for android.
    https://www.wikihow.com/Install-APK-Files-on-Android There are more how-to's when you use a search engine like Google.
  • F
    fernandoh replied to the thread Mantis app for android.
    Como instalar app
  • h-elsner
    h-elsner replied to the thread Drone Randomly Crashed.
    I see a lot of relatively short flights where the voltage goes down to around 14V fast. Saying the battery is good, the problem may also...
  • h-elsner
    h-elsner replied to the thread Drone Randomly Crashed.
    The battery shows 16.4V without power demands (4.1V per cell), looks like fully charged. The voltage breaks down to 15.6V when motors...
  • M
    mreed777 replied to the thread Drone Randomly Crashed.
    Interesting. The battery was showing full, or close to full when I took off, and I never got any low voltage warnings, even when...
  • h-elsner
    h-elsner replied to the thread Drone Randomly Crashed.
    The telemetry and MAVlink ends abruptly in around 5m elevation. No error messages or other indications so far until the last data set...
    • Telemetry00094_3charts_zoom.png
    • Telemetry00094_Batt.png
    • Telemetry00094_3charts.png