Hello All,
I just received my H. I have been flying a DJI Phantom for a few years and decided to upgrade. I chose the Yuneec Typhoon H. With all the new bells and whistles, I had to at least unbox and try as much as I could. 60 mph winds on the East coast of the US are keeping me grounded for now.
Straight from the box, all of the latest updates were installed already. No new updates to perform on the H or the ST+. The controller and drone were bound at the factory. Turned everything on and studied lights. Everything worked as described. Equipped with RealSense.
Then I found the "Wizard." So I bound the wizard to the H and entered "Team" mode. Again, using the wizard, everything was as described in the literature.
So today I took out the H and much to my disappointment, none of the lights were right, and I kept getting a warning telling me RealSense was not active and to restart the drone if RealSense is installed. All I could get was a flashing blue light on the LED status light. Everything I tried is not as important as what I learned. I had to take the H out of "Team" mode, and reset to single mode. Basically, I think it "unpairs" the H from the Wizard and automatically re-binds to the ST16 controller. Once done, all LED status lights returned to normal. more especially the warnings about RealSense stopped.
So if you have used the Wizard, this may be a simple solution for the OBS avoid and RealSense not installed warnings.