Dear all,
I think I have applied wrong firmware on my CGO ET camera which is installed on the Typhoon H copter. Wanted to do a Firmware upgrade but think I have downloaded wrong firmware from Yuneec Site.
The only firmware for CGO ET which was downloadable was for copter H520 "Firmware CGOET H520 EU 0.2.14". Since I have uploaded this firmware, binding with ST16 and copter and camera is still possible but I always get the message on ST16 RC that there is a problem initializing camera and I don't get a picture on the screen.
Can someone help me please? Think after uploading correct firmware which is the good one for CGOET with using on Typhoon H copter then I may work well again.
Can somebody provide the correct firmware which I need? Or maybe I am wrong at that will not be the problem...?
How the firmware can be uploaded to camera? It looks like the upload starts after booting up the copter with firmware on SD card which is in the camera slot, right?
Thanks a lot in advance for your help...
Regards
Olize
I think I have applied wrong firmware on my CGO ET camera which is installed on the Typhoon H copter. Wanted to do a Firmware upgrade but think I have downloaded wrong firmware from Yuneec Site.
The only firmware for CGO ET which was downloadable was for copter H520 "Firmware CGOET H520 EU 0.2.14". Since I have uploaded this firmware, binding with ST16 and copter and camera is still possible but I always get the message on ST16 RC that there is a problem initializing camera and I don't get a picture on the screen.
Can someone help me please? Think after uploading correct firmware which is the good one for CGOET with using on Typhoon H copter then I may work well again.
Can somebody provide the correct firmware which I need? Or maybe I am wrong at that will not be the problem...?
How the firmware can be uploaded to camera? It looks like the upload starts after booting up the copter with firmware on SD card which is in the camera slot, right?
Thanks a lot in advance for your help...
Regards
Olize
Last edited: