I completed my updates to the H and the ST16, and the new versions show up when I view the current operating versions in the ST16 and H, but only the camera is bound. When I try to force the Bind mode by tipping the drone forward twice or even three times, the light just stays blue and does not turn orange. When I completed the first upload it did change to orange, but after the final update it will not. ( I went from original operating system to the most current by stepping through two difference updates sent to me by Yuneec Support with instructions)
Any Ideas?
I read a prior thread where someone thought there was a reset or forced bind button inside the H.
Anyone?
Any Ideas?
I read a prior thread where someone thought there was a reset or forced bind button inside the H.
Anyone?