Recent content by dagmba

Hey just wanted to check in with you about the H920. How did your recovery go? Hopefully you're back up to steam. David

OK, sounds good to me....hope your recovery goes well.

It is still available. I am in the Houston, TX area...Spring, TX near The Woodlands, TX, to be more specific.

Sorry, I only now saw this post. If you're still interested, I could ship it for $125.

For Sale: H920 Tornado V18 camera (new in box) CG04 Camera (new in case) Pro Action Grips (new in case) Battery Charger/Conditioner + 6 new batteries ST24 Controller Rigid Cases for Drone, CG04 and Action Grips Drone lighting (see pic) and strobes ASKING $850 OBO plus shipping For sale are the...

I don't know what I did, but I was able to get the H920 to show it was paired with the ST24. I actually flew it for the first time on Wednesday and it did great! Sadly, the next time I turned it on I get a beeping sound and the indicator light is rapidly flashing blue (indicating it is not...

I did as you suggested, ( get H920 into bind mode - success, then follow single mode bind directions - no luck) without success. Two things I don't understand: (1) I am using the CG04 (though I have a V18 and the Panasonic GH4, too) and it does not appear as a camera that I can select from...

Thanks for your help. If I ONLY turn on the aircraft, it does flash blue, then yellow, following the tilt exercise. With the a/c off, when I turn on the ST24 and follow step 1 of the single mode binding instructions, it immediately goes to a screen that says: RC:connecting... WIFI...

Thank you very much. I tried this and, so far, it has not worked. What is the LK58 that is referred to? Also, when I power on the ST24 and choose FPV, then model select, I do not get the option to choose the CGO4, only "H920 GB603" or "new model" appears. I also will get the message to...

I purchased a H920 (non +) recently and the CGO4 camera. (I also have the Panasonic GH4 camera and gimbal for it...) I set it up with the CGO4 attached and while the gimbal boots and turns the camera during the boot up process, it does nothing afterwards. Also, I am unable to start the motors...