Recent content by fly101

The Hardware Monitor has become part of the checklist...

Question??? If you realize its flying off due to the wrong CCC being loaded can you not hit exit to stop the CCC flight?

Hi Steve, All I did was fix the one loose connector and put it back together.. I didn't spray the pots.. I Now have three flights we're I've flown full batteries down to just past first battery warning.. No problems.. Now we are looking at the Same scenario like last time.. I flew a few times...

I've tried several of the off brand batteries .. Both Powerextra 6300 H batteries Swelled with less then 20 flights... UltraX 6300 H battery still going strong with over 35 flights and flight times are 3 to 4 min. longer then OEM... I've also been using a Bonacell brand 5400 in my Q500 4K and...

Checked all channels and found everything on the left of the screen correct.. I believe the connector that was not glued and the potentiometers are playing a big roll in a lot of the problems we are having.. Which in turn falls back on the quality of the parts being used and the reason is the...

Well after a little research this evening I found a few things with the potentiometers on the ST16.. With my H and transmitter being shipped to three different repair shops I cant say who did what but it seems they know the connectors on the potentiometers are a problem because they used what...

So what do you think caused this mixing to occur? Especially mixing from one stick to another? Is there a higher quality potentiometer that we could use? I would like to eliminate the problem instead of worrying about reoccurring chances of crashing due to equipment failure..

So I guess so far no one has figured out how to turn mixing on and off without having to do a complete firmware reset on the Transmitter?

My channel settings do not show the mix on the boxes on left side of screen..

It received a complete firmware update at United Radio and flew flawless when I got it back .. it set for two weeks before I went to fly again again and it had no forward or back control.. now I find with further examination it has mixing between the yaw control and the forward and back...

Send me info and price on tray also please..

Call yuneec and talk with them.. if you had work done while under warranty and your warranty has just resently expired they will still work with you.. sometimes they will do the repairs but you pay the shipping to get it to them..

Ok guys it seems there are serious problem with the control stick programing on the ST16's.. I have been told by Yuneec my st16 needs the control sticks replaced and then the repair shops get it and they say its not the sticks its a firmware problem.. 3 times.. each time it comes back and works...

I have sent my ST16 off to have the stick Units replaced 3 times and all 3 times it was sent back to me saying the sticks were not the problem.. Everything worked good for several weeks and now I again have a sluggish right stick that is moving real slow while watching the hardware monitor...

I would buy GiFi before others in the low cost battery line