Recent content by Nik

Dear friends, help! Need firmware for stm32f37cct6 processor from the board of gimbal camera CGO3 V04. Drone – Yuneec typhoon 4k 500+ . Thank you in advance )

Ok, my bad, just check this link, thank you.

Thank you all guys, I bound the camera but it is unfortunately still not working. Here is a link to a very short video about my drone, hope it shows the problem. Thank you in advice, Nik

Hello, the camera is not setting up automatically as I turn on the drone. It is also not moving, I can't make it look up or down by controlling the slider from the left side of ST10+. It also shows that "Failed to communicate with camera". Can you please help me? Thank you in advance, Nik

Thank you for our help )

Hi, I have just bought a drone - Yuneec Q500 4K. I am living in Seattle. Where I can fix it? Thank you.