Recent content by Skyhighmike6

Yeh I checked those as well, could it have anything to do with updating or just not having any firmware or anything?

I un-screwed the clip on the drone to check, and then for the camera I took off the shock dampeners and un-screwed the little box that holds the 6 connector points, then I screwed it all back together.

Hello, my camera wont move, as in tilt or pan and all the connectors are fine. Should I rese it to factory settings or what should I do to try to re-boot it? It also says failure to initiate camera, but again the camera gimbal works but wont move when I use the controllers. Thanks

I double checked where they connect and it still doesn't want to pan or tilt, yet the gimbal part still works. All connectors are in good shape.

Hi there, my drone had recently crashed in which no wires were cut of any sort, I just need a new leg and mounting bracket for the camera. I now start up the drone but the camera is turned about 20 degrees from where it should normally be. It also does not tilt at all. Should I reset it to...