Recent content by Standageadrian

Okay great if ten pound is there a part code I can look out for to purchase in UK?

Hi all had small crash and landing foot snapped off the main rod at the base. Can it be glued back on with like gorilla glue or better to go to yuneec and buy new leg and landing foot?

Thanks Steve yes please if you have it

Jack thank you I'm going to try it this way. Should make the camera seek and recalibrate automatically thanks. I'll let you know how I get on. Thanks again good idea!

AH Thanks just the advice I need. The slip ring came with nothing at at all so maybe I soldered green cable to wrong point. I'll contact them thank you

Thanks AH I'll take the queue and find a professional to find the problem. You know when you ask your kid to do vacuuming and they do half a job lol. That's how I feel. Camera works. Can't control it. So I guess I'll call a few local repair shops. Cheers all. If I get info from repair dudes I'll...

Thanks AH. It's ego? Dunno. We worked hard and did video and photos and hoped success so we could post it and provide something to new h plus owners but seems final hurdle too big with no tools like the h has. Well it has gimble calibration which plus does not that's what frustrates. If I found...

Thanks et phone. Not the best news I used to service computers so I'm loathe to let things beat me especially with all you helpful guys and gals out there

Hi Steve yes confident as only the green cable was ripped so compared the board with the h board and put it in same place... As confident as I can be then. Its a shame as we took 3 hours doing the repair. Could fly without camera controls but sometimes you want to look down which would be a...

Thank you. I really don't want to send to a repair centre as I know that this procedure is common on the h. I know the motor is ok because it spins like a carousel then stops. Or it will twitch left and back centre and stop. Its the binding or deeper calibration that's the issue I believe. On...

Hi everyone. I'm posting a new thread as I desperately need a pointer. I'll keep it short. Crashed into a tree camera c23 came off. Ordered slip ring. With help from this community managed to get all reattached and soldered on correct points as per the H. Camera now works fine but when craft is...

I'll be interested in this as I had to get new slip ring to reattach c23. Camera works but no controls. Seems to spin like it's lost its mine when it's bound. Maybe is there somewhere in h plus controller to calibrate camera motor? Not sure

Thanks. So I know how to get into hidden menu for accelerometer and gyro however the post you mentioned says go to settings and then about controller but I don't have that on mine which is new h plus controller. So still need to know hidden menu for camera gimble calibration

Thank you password correct. Still have orange flashing light and camera spins on boot up. Will not respond to pan tilt commands. Could live without pan and tilt but would like it work properly. Other than reset camera is there a camera cabilbration tool? Cannot see one. Vid attached. Well tried...

Hey all we finally fixed it! Will post video and photos for correct procedure soon if interested. Only one issue. On boot of craft the camera spins like a bucking horse. So I reset WiFi connection with the controller and it was fine. However its asking me for camera password. See photo. Anyone...