- Joined
- Dec 27, 2016
- Messages
- 5
- Reaction score
- 2
- Age
- 48
Just got my Breeze yesterday, decided to test it out inside because weather outside was crap. Followed all the instructions on how to fly in doors, checked the firmware it was up to date and turned GPS off. Everything went accordingly, it hovered at three feet, the wind from the blades caused it to move side to side which was expected. I raised it to about five feet and it became more staple in the air as it hovered. I toggled the camera, I took a picture and viewed it while it hovered. Then it beeped, flew straight up to the ceiling, popped two guards off and vigorously circled the ceiling while bouncing. I tried throttle down but it wasn't communicating, then it beeped again and just dropped nine feet to the floor. The phone display IPS failure which I assume shut off the drone. I examined the drone no cracks, three blades are ruined, the GPS cover popped off. I pulled the battery out for awhile and put it back together and powered it up. GPS was showing 15, the drone lights was showing green on the wing and full blue at the back but the IPS was orange on the phone and the camera is working fine. I checked the flight log and it show 3 minutes and 30 seconds, changed the blades but I'm scared to test it again. When I tested inside there is lots of room, good lighting, pine floors and only a couch for an obstacle.