Typphon H + ST16- cannot be connected.
Could you help me? Typhon H + ST16 flies and the camera also transmits the image. The drone is good! I brought another driver ST16 and the drone just flashes blue, ST16 does not have Volts on the display (as there is no battery), the camera transmits the image to this ST16 and also takes photos. However, a drone with this ST16 will not start the engines. I did: I connected the drone (Model Select) with the ST16, loaded the camera (I gave the password). The drone does not start the engines. The camera image on the ST16 has. How to find out where the defect is. I have the WTFDproject Rev80-83 manual on my PC.
Thanks for the information.
The mention of only the blue flashing LED strongly suggests the ST16 is not bound to the Typhoon H. Selecting the drone in Model Select is
only a part of the Drone/Controller binding process. The standard binding process may be adequate if there are no problems with the equipment.
Standard BINDING process for the Typhoon H and/or the Camera
Step 1) Turn on the ST16 wait until the initialization completes then turn on the aircraft. Caution: Verify the 2.4Ghz & 5.8Ghz icons are present in upper right corner of ST16 to properly bind to the Typhoon H.
Note: Step 2 not required for binding ONLY the Camera.
Step 2) Lean the Typhoon H in the forward direction to 45 degrees - twice – verify the main LED blinks orange
– if not repeat the procedure.
Step 3) Tap the “Refresh” button on the ST16.
Step 4) Select the “SR24_XXXXX” under the “Aircraft Model” column to bind the
Typhoon H and/or the “CGO 3P_XXXXX” under the “Camera” column to bind the Camera. Tap the “BIND” button, enter the PASSWORD “1234567890”
When asked, tap “OK”. MAY TAKE A MINUTE or TWO TO COMPLETE.
Step 5) When you hear two long beeps the Typhoon H Binding was successful.
Step 6) Tap the “Back” [ ] button to return to the main screen.
Telemetry data from the Typhoon H will be displayed on the left side of
the ST16 screen and what the camera is viewing will be displayed on screen.
If the standard process does not work, I would suggest using the
Typhoon H Binding Verification guidance from the WTFDproject document to determine where the problem is occurring.
Use the direct link above or the latest revision of the full document (
Way To Fix Drones project) as this attachment was recently edited to correct some errors in the step numbers.