Gimbal problem

DK-Fire · Feb 24, 2017

Just recieved my new Typhoon Pro today.
When turned on, the gimbal keeps rotating very slovly... all the way rond again and again.
Have tried to calibrate, but still the same.
Anyone tried this before ? :-/

Drone dog · Feb 24, 2017

No, but you might try a camera reset from the ST16

DK-Fire · Feb 24, 2017

But Can only find the calibrate button

ThunderChicken · Feb 24, 2017

Are you linked to your controller when the camera wanders? Is your Pan Control knob centered? Have you ever crashed it? You might go in the calibration screen for the controller and adjust the Pan setting.

Drone dog · Feb 24, 2017

DK-Fire said:
But Can only find the calibrate button

It's not in the calibrate menu it's the camera menu

DK-Fire · Feb 24, 2017

The pan knob is i neutral... but if i try to pan it on the knob to the left, and turn it back to neutral.. it keeps turning left very slowly. And the same if i pan to the right and put in in neutral.. it keeps turning right slowly.
And i am linked to controller..

ThunderChicken · Feb 24, 2017

Go to System settings and then Hardware monitor. It will show what the controller is doing.
Work the Pan mode switch a couple of times, first one position then all the way to the other and see if it stops.

D- drone · Feb 25, 2017

@ DK-Fire
I've had my H pro for about a week now and have took it out a few times so I don't know a lot about it yet but mine did the same thing yesterday with the camera so I did the compass calibration and it fixed the issue with the camera.
Good luck

Sent from my SM-N920V using Tapatalk

FlushVision · Feb 25, 2017

Mine displayed this anomaly yesterday during it's first flight after a firmware update (not the update released yesterday, it was the update from November last year). However I landed it and power-cycled the aircraft and took off again. That cleared the problem. I ran a further battery through it yesterday and all seemed well.

DK-Fire · Feb 26, 2017

I got it to stop from spinning, by updating it.
Now the only problem is that the camera is pointing slightly to the right

ThunderChicken · Feb 26, 2017

use the pan knob on the controller to get it to center.

DK-Fire · Feb 26, 2017

Yes but when the Pan knob is centeret, the camera shuld be also... but it's pointing to the right, when knob is centeret..

ThunderChicken · Feb 26, 2017

What I'm saying is use the knob to get it to turn to center then set the knob back to center. It will turn slowly to which ever direction you turn it and when it hits center set the knob back to center and the camera should be centered.

prathbun · Feb 26, 2017

ThunderChicken said:
What I'm saying is use the knob to get it to turn to center then set the knob back to center. It will turn slowly to which ever direction you turn it and when it hits center set the knob back to center and the camera should be centered.

Sorry ThunderChicken, but for the life of me I can't understand what you said there...

Rayray · Feb 26, 2017

DK-Fire said:
I got it to stop from spinning, by updating it.
Now the only problem is that the camera is pointing slightly to the right

Did you re-calibrate the gimbal? (correctly)

Try unplugging the camera, examine the 2 rows of spring contacts on the gimbal and the craft. At times one will stick down.