Repair

[bobcat]

Does anyone know how to remove the arm on a cinnama 2 exo drone. I have taken it down to nothing and can't figure out how to remove the pin holding the two arms in place

 

[DoomMeister]

Never heard of that one. You might check our sibling forum Drone Pilots Community to see if anyone there may know. It covers a lot of the off brand drones.

 

[Chris Koch]

Does anyone know how to remove the arm on a cinnama 2 exo drone. I have taken it down to nothing and can't figure out how to remove the pin holding the two arms in place

EXO Drones | EXO Cinemaster 2, this is their official website, maybe there is help here for you

 

[Jimbarb]

Does anyone know how to remove the arm on a cinnama 2 exo drone. I have taken it down to nothing and can't figure out how to remove the pin holding the two arms in place

I just had mine replaced by QC Guy but now it won’t connect to GPS. Something must have happened to it when the motor got stuck in the grass. The motor got hot and fell off.

 

[boxingtkos]

I ran into the same issue with my Cinnama 2 Exo drone. I had a tough time with the pin too, but I found that using a small flathead screwdriver helped to gently pry it out. It was a bit stubborn, so I sprayed some WD-40 around the pin and let it sit for a minute, then it came loose more easily. Just be careful not to use too much force, since it’s easy to damage the frame if you do. It took a little patience, but once it was free, I could move on with disassembling it.