What does this mean?
- Thread starter arrozconbryan
- Start date
All light on aircraft are off and the rc will not allow me to bind. I successfully updated the controller and now it won’t connect to rc or let me complete the update.
It's been a couple hours since your last update, so I don't know if you were able to get it resolved. I think you were in the OTA update process?
1.) Where you able to complete the update?
2.) If not, where are you in the process?
3.) What was the original build?
4.) Were you trying to go to any Build other than Build 822 on the normal OTA site?
1.) Where you able to complete the update?
2.) If not, where are you in the process?
3.) What was the original build?
4.) Were you trying to go to any Build other than Build 822 on the normal OTA site?
@arrozconbryan ,
Where are you finding these H Plus machines? Are they still on the shelf in your area?
Where are you finding these H Plus machines? Are they still on the shelf in your area?
I got it from b&h audio video. They told me it’s just an error with the drone and I have to send it back...... again.
This is very likely not a problem with a new aircraft and comes from trying to update without following the procedure to the letter.
If you are getting a new from the factory system you should have tried flying it before trying to do any kind of update. This is to verify that the system is functional before trying to do any kind of update.
If you are purchasing a refurbished unit it should already have been updated before being shipped to you.
If you are getting a new from the factory system you should have tried flying it before trying to do any kind of update. This is to verify that the system is functional before trying to do any kind of update.
If you are purchasing a refurbished unit it should already have been updated before being shipped to you.
And I would add that if it is functional, do not update it. There is no real benefit to updating a functional system if it is performing all you need it to do.
