So I am running, v3.04 b30 on my H st16.
I wrote Yuneec a month ago asking for the altitude waiver.
They linked to a page where I DL'd a PDF, converted to WORD and
filled it out - then emailed it to them. 2 weeks later, a reply came
stating NO NEED.
So I GUI'd up and set the altitude on the H to 240 meters. Double 120m or 400 feet.
I go fly her. LIMIT: 399 ft. WHY SO?
Does a person NEED that CODE?
Why didn't my bird accept the change?
Now THIS: Just before the GUI connect, I installed a new wifi printer to my laptop.
(It was not easy to do.)
After - I had to LOAD a port driver for the GUI, now my printer does not connnect! (Offline)
Any computer geek with suggestions?
Egads, doncha love modern powerful electronics...
I wrote Yuneec a month ago asking for the altitude waiver.
They linked to a page where I DL'd a PDF, converted to WORD and
filled it out - then emailed it to them. 2 weeks later, a reply came
stating NO NEED.
So I GUI'd up and set the altitude on the H to 240 meters. Double 120m or 400 feet.
I go fly her. LIMIT: 399 ft. WHY SO?
Does a person NEED that CODE?
Why didn't my bird accept the change?
Now THIS: Just before the GUI connect, I installed a new wifi printer to my laptop.
(It was not easy to do.)
After - I had to LOAD a port driver for the GUI, now my printer does not connnect! (Offline)
Any computer geek with suggestions?
Egads, doncha love modern powerful electronics...