- Joined
- Aug 23, 2016
- Messages
- 104
- Reaction score
- 21
Finally got to test fly the H after updating a couple days ago.. had trouble updating the H with the OTA so did it with SD card .. cleared data in flight mode folder .. calibrated the compass .. passed, went inside on a level table and calibrated the accelerometer .. passed .. then the gimbal, at end of gimbal calibration it was a bit off center to the left but a restart corrected that .. now to the flight test .. turned both on and let them sync, waited for GPS and Sat's (20 for both), checked all my telemetry, knobs, levers and everything was a go .. shot up about 25' and hovered testing my sticks, left, right, forward, back, up, down, seemed good so up, up and away, that's when I noticed the sticks seemed to be very touchy, just barely push and the H is moving, also noticed a bit of drift to the right that I never had before but then there was wind gusts at about 15 mph, so I'm blaming the drift on the very touchy sticks and the wind plus clearing all the flight mode data, I'm assuming it may take a few flights for the H to get GPS and Sat data back into it's little brain and everything will be fine, so other than very touchy sticks and a bit of drift which is by no means requiring a Yuneec CS call .. oh ya .. it did hover in place pretty solid .. didn't try all the new features but the panorama and cruse worked well and I'll get to all the others as time goes .. over all .. I'm happy !!
Foot Note: I've come to the assumption that a simple re-boot on both the H and the ST16 during and after updates and calibrations does wonders.
Foot Note: I've come to the assumption that a simple re-boot on both the H and the ST16 during and after updates and calibrations does wonders.