Hi all,
I have just purchased a Typhoon H plus all be it second hand but hardly used by a commercial pilot as a back up for a month. This is my first Yuneec product but not my first drone. I have read and digested the less than comprehensive manual and when I try to fire up the rotors with the red button I get nothing but a series of beeps and then red lights flashing on all props. The rotors will start if I use the takeoff button on screen but I still have no control over rotor power so no take off and as it should after approx 10 seconds it shuts down the rotors. The little note menu says no flight mode selected and flight mode not available when ever I try to select any mode.
However if I switch to Manual mode all is great everything works except there are no feedback information regarding hight distance V/S nothing all I get is the distance I was when the controller first connected to the UAV I have full control of all camera functions flight in manual mode, but I cannot get it to work in Angle, sport/Smart modes.
Any assistance would be very greatly appreciated.
It might be worth pointing out the Drone was unlocked by Yuneec for a CAA pilot and was reverted for the sale as I am awaiting my PfCO. Not sure that would make a difference. And as per NATS and 2 other apps I am not in any Airspace close to some firing ranges but not in any of them.
I have just purchased a Typhoon H plus all be it second hand but hardly used by a commercial pilot as a back up for a month. This is my first Yuneec product but not my first drone. I have read and digested the less than comprehensive manual and when I try to fire up the rotors with the red button I get nothing but a series of beeps and then red lights flashing on all props. The rotors will start if I use the takeoff button on screen but I still have no control over rotor power so no take off and as it should after approx 10 seconds it shuts down the rotors. The little note menu says no flight mode selected and flight mode not available when ever I try to select any mode.
However if I switch to Manual mode all is great everything works except there are no feedback information regarding hight distance V/S nothing all I get is the distance I was when the controller first connected to the UAV I have full control of all camera functions flight in manual mode, but I cannot get it to work in Angle, sport/Smart modes.
Any assistance would be very greatly appreciated.
It might be worth pointing out the Drone was unlocked by Yuneec for a CAA pilot and was reverted for the sale as I am awaiting my PfCO. Not sure that would make a difference. And as per NATS and 2 other apps I am not in any Airspace close to some firing ranges but not in any of them.