Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Clive Spencer

  1. C

    Gently Use a hole punch. Or a small flat nosed pliers

    Gently Use a hole punch. Or a small flat nosed pliers
  2. C

    Silicone spray

    No Murray, just replaced a broken leg and elbow ect. Haven't try it out yet and thought I should help it to move more freely. As a old newly at this I thought it better to prevent than do nothing just in case. After all you experienced pilot have such a vaste amount of knowledge which I'm sure...
  3. C

    Silicone spray

    Point taken Rayray ill use graphite, once again many thanks from an old fart
  4. C

    Silicone spray

    No gwhutoon I'm in UK, many thanks for reply
  5. C

    Silicone spray

    Appreciate your response Rayray, but it was a lubricant that I was looking for but the knowledge of a a good contact cleaner is invaluable. May thanks, love reading your posts so valuable with info.
  6. C

    Silicone spray

    there are some members on this forum with fantastic knowledge so could you please advise me on the best silicone spray to use on me H's landing gear elbows and where to purchase please, thanking you in advance.
  7. C

    Warning to land, 5 motors running

    Thank you Steve for explanation
  8. C

    Warning to land, 5 motors running

    Thanks Rayray but could you explain your comment., I believe you have helped me before.
  9. C

    Warning to land, 5 motors running

    Can anyone help a newbie H owner please, I crashed after a slight run away, couldn't gain control and broke one landing leg and one propeller which I replaced. I went out into my garden to get GPS signal and to test without the propellers. I went through the statuary start up procedure when the...
  10. C

    Landing gear actuator

    Thanks Craig, I understand now. Appreciate you taking the time to explain
  11. C

    Landing gear actuator

    Thanks Craig, but what do you mean by cycle. I bought the actual actuator with the nuckle complete.
  12. C

    Landing gear actuator

    Hi, H pilots, just had a crash and broke the actuator nuckle. Brought a replacement and fitted it but have a problem, the repaired actuator nuckle is in the landing down position whilst the other is in the up position. Is there a problem with lining the two arms up, does it line itself up or do...
  13. C

    Where to find controller necklace strap holder replacement

    take great care as the shades front two pins are too short, they pop out too easily, best use the lugs provided.
  14. C

    Drone industry takes a downturn

    Thanks B Scott I had ignored the 1st warning and only landed after about 71/2 mins, even flew away from landing zone but did find control a little difficult, landed safely