Recent content by polskipilot

Hello. What could be the reason for the drone drifting to one side (left) when it is at an altitude of over 50 m, in almost windless weather, with compass calibration performed, sticks calibrated, switched on in ANGLE mode, and yet it slowly drifts away. I have flown various Yuneec models and...

In Poland, there is a service centre in Krakow that specialises in repairing Yuneec drones and reportedly still has the last service parts for various models, which it repairs using original parts. You can contact them at [email protected]

I am sending photos of the cables; they do indeed look damaged. Is it necessary to replace the entire rotating mount of the camera gimbal arm, or can it be repaired somehow? Could this damage be the reason why the camera cannot be controlled despite the image from the camera?

Unfortunately, I caught a cold, which is why it took a while. Nothing has changed yet, and I am sending photos of the controller and the gimbal with wires in the attachment. The green wire was torn out and is soldered. Which of the wires is responsible for the vertical movement of the camera?

Unfortunately, I still don't know where to look for point 6. As for the connection from the board to the slip ring, it is connected correctly, there is still an image but no camera control.

1. Yes, it changes colour to green. 2. Not only the drone from time to time. 3. Yes, when I check it manually, there is resistance and it returns to level on its own. 4. Yes, the slider works and the camera does not move. 5. Yes, it is visible in the ‘equipment monitor’, but I do not know where...

1. Yes, it changes colour to green. 2. Not only the drone from time to time. 3. Yes, when I check it manually, there is resistance and it returns to level on its own. 4. Yes, the slider works and the camera does not move. 5. Yes, it is visible in the ‘equipment monitor’, but I do not know where...

Thank you for the comprehensive information, I will do as you wrote. I still have a problem with the camera in Typhoon H, but that is a question for another thread. Could you take a look at it and give me some advice?

The problem concerns the camera, which has an image but unfortunately does not move. When the drone is turned on, the light on the back of the drone first flashes green and then switches to purple. Attempting to bind the drone does not cause any reaction, i.e. the rear LED continues to flash...

After several attempts, I managed to click on the ‘Settings’ icon and reset the entire tablet, then I inserted the card into the controller with the Data Pilot system and installed it, but here I have more problems: 1. I have deleted all missions, but after entering the Android system and...

How can I restore the factory settings on the controller if I cannot access the system because I am immediately redirected to an error screen? I cannot even see if Data Pilot or Data Pilot 2 is installed because Android does not turn on. When I connect the controller to my computer with a cable...

I have an H520 drone with an E90 camera and unfortunately I can't do anything because as soon as I turn on the device, I get these messages, and even if it connects to the camera after a while, I immediately get the messages shown in the photos. After inserting the ‘data pilot’ card, the...

Thank you for the information, but I have other problems. After turning on the drone, there is no image, but the camera can be controlled. After turning the drone upside down, all LEDs continue to light up normally and do not switch to binding mode despite unpairing, as shown in the video. After...

Hello. I have an H+ drone with a C23 camera, but unfortunately there is no image. How do I connect them so that I can see the image? I am sending photos.

I have an H520 drone with an E90 camera and am having trouble installing the update. I keep getting the same error and the new update is not available. What can I do about this?