Practicing for my commercial license and knowing you have to turn the transmitter off, after plucking up the courage, tried exactly that. It’s my understanding that for CAA it has to return home and land.
Once the transmitter was turned off, it seemed to sit there for a few (felt very long) seconds, then climbed and started heading home. Once it returned it just sat there hovering, with me below with switched off controller in hand. It hovered for a few minutes until I turned the transmitter back on and it connected to let me control and land.
Question is, is there a setting to enable auto land if the control signal is lost?
I’ve looked but I can’t see one.
Any help gratefully received.
Once the transmitter was turned off, it seemed to sit there for a few (felt very long) seconds, then climbed and started heading home. Once it returned it just sat there hovering, with me below with switched off controller in hand. It hovered for a few minutes until I turned the transmitter back on and it connected to let me control and land.
Question is, is there a setting to enable auto land if the control signal is lost?
I’ve looked but I can’t see one.
Any help gratefully received.