A few day ago I had an unexpected rapid descend while the gear was up. In fact the camera took a major hit. The vertical beam was bent as well as several cracks in the plastic parts.
Most of the repair was done without any problems. The camera is working fine but the gimbal was causing troubles. It did nothing unusual but the pitch was not working at all. Quickly I figured out, that it was caused by the connector from the Mainboard to the pitch motor, which was completly ripped of the PCB.
In fact I replaced the mainboard but now the gimbal is going absolutly crazy. There is no better way to describe whats happening. It just keeps spinning around z-axis, banging around x- and y-axis and is not reacting to anything.
The mainboard ist deffinitly working since I took it out of a working gimbal with broken camera. As soon as I swap back the mainboards everthing is working fine again. But still I have no pitch for obvious reasons.
Do you know any help? I am quiet frustrated right now.
Most of the repair was done without any problems. The camera is working fine but the gimbal was causing troubles. It did nothing unusual but the pitch was not working at all. Quickly I figured out, that it was caused by the connector from the Mainboard to the pitch motor, which was completly ripped of the PCB.
In fact I replaced the mainboard but now the gimbal is going absolutly crazy. There is no better way to describe whats happening. It just keeps spinning around z-axis, banging around x- and y-axis and is not reacting to anything.
The mainboard ist deffinitly working since I took it out of a working gimbal with broken camera. As soon as I swap back the mainboards everthing is working fine again. But still I have no pitch for obvious reasons.
Do you know any help? I am quiet frustrated right now.