First crash. Gimbale wired cables - after FIX Up/Down Cam problem.

[Grzegorz.z]

Hi Everyone.
I'm a beginner pilot. Yuneec Q500 4k.
I'm flying in smart mode only. During my third flight I had an accident. I completely lost control of my drone. Fortunately my quadro finish on tree.
I had a simmiliar situaktion like moste people on forum. I had broken wire on gimbal.
I welded broken cables. When i powered on radio and drone - camera is working, gimbal is working also, but stearing up/down finction is not working. I replaced cable between gimbal and drone (second one from accesories) - unfortunately camera still is not reaction on up/down controls.
I looked on mainboard in gimbal and I dont seen 2 electronic elements (diod or resistors) next to white socket on gimbal to drone calbel. I have in this place only weld points. Model my gimbal mainbord is 1534.
Somebady have any idea's why up/down is not working?
Thanks a lot.
Grzegorz

 

[Jafo]

First, try rebinding the camera and box.
Next, try reloading the firmware in the camera and the drone and see if fixes it.
Reloading the camera firmware worked for me when I had a similar issue.
Let us know what you learn and good luck,
Jafo

 

[Grzegorz.z]

Jafo - thanks for reply.
I tried upgrade firmware but i have latest alredy. When I inserted SDcard camera wasn't made upgrade again.I can't connet by USB - I must contact with supplier because I have USB-Drone connection problem from begining (I tried on few computer with different system and with different adrivers). Do You have any idea how I can upgrade camera firmware if latest was'nt upgrade again on this same version?

 

[Jafo]

Hook up the GUI to your drone and try a Camera Gimble Calibration.