My ST10+ is no longer responding (charging)

[DoWa]

Hello together
When I wanted to charge my remote control (ST10+) this morning I notice no reaction from the remote control. It has not loaded. I then wanted to turn on the remote control but nothing worked anymore. What should I do?

 

[Pier2162]

Hello.
Have you tried to leave it plugged into the charger for a few hours?
It could be that the battery is completely discharged and needs some time to reach a minimum level for wake up the transmitter.
Before doing so, it would be good to take out the battery and check its voltage with a multimeter, then report the results here.

 

[Vaklin]

If the boot partition is changed or destroyed the trickle charging will not work too. Better is to measure the battery voltage first.

 

[WTFDproject]

Better is to measure the battery voltage first.

@Vaklin makes a good point. The ST10+ charger will not start if the battery voltage is too low. You may need to take the battery out and use an external charger to boost the battery enough for the ST10+ charger to work properly.