Quick Release Propeller Installation

[jgann055]

Can anyone take a pic of both sides of the quick release propeller for the Tornado H920+ ? They should be easy to install, but for some reason I am having difficulty. TIA

 

[jannislh]

They are easy to install. Is it possible that you have mixed them up? Maybe you are using the wrong propeller or the wrong mounting plate. You cannot mix A and B mounts since they mount in the opposite direction. It is a very common mistake.

 

[jgann055]

My H920+ did not have the quick release hardware installed. I bought some and am having difficulty installing the pieces to the motors and props. I think some photos might help.

 

[jannislh]

My H920+ did not have the quick release hardware installed. I bought some and am having difficulty installing the pieces to the motors and props. I think some photos might help.

Are you sure it is a H920+ not a H920? The plus is usually delivered with quick release already mounted. Unfortunately I cannot supply any photos.

Nevertheless they should fit just fine. Motors and propellers are the same on both versions.

 

[seabee]

My H920+ did not have the quick release hardware installed. I bought some and am having difficulty installing the pieces to the motors and props. I think some photos might help.

These photos might help. Torque to 6-8 in.lbs. Recommend using Loctite 222 Threadlocker and balancing the props. Do you have the ST16 controller? If you have the ST24 you probably have a H920 not the plus.

 

[jgann055]

Thank you Seabee. I got mine used, and the previous owner didn't have them installed.

 

[giorgio]

Queste foto potrebbero aiutare. Coppia a 6-8 pollici/libbre. Si consiglia di utilizzare Loctite 222 Threadlocker e di bilanciare i puntelli. Hai il controller ST16? Se hai l'ST24 probabilmente hai un H920 non il vantaggio.View attachment 24863View attachment 24864View attachment 24865

SALVE SECONDO VOI è POSSIBILE ABBINARE ELICHE PIEGHEVOLI SUL TORNADO H 920? GRAZIE