Hi All,
On the UAV flight simulator, when I disable GPS on the remote everything is fine and GPS switches off. The simulator then flies without GPS....no surprises so far.
However, when I try to re-enable GPS on the remote, the remote already says it is on, but it isn't. The slider seems to be locked in the on position and off is no longer an option.
The only way I have found to fix this is to rebind. The connection is then re-established with GPS active and all is well.
I have a Q5004K using the ST10+. I have posted in general as the issue may also apply to the ST10 or ST16 too.
Question: Am I doing something wrong and there is an easy way to resolve this, or is it just a quirk of the simulation and what I am currently doing is my only option?
FYI: I have switched off GPS when connected my real Q500 and successfully re-enabled it. For clarity though I did this on my kitchen table just to check the option worked; I have never done it when flying.
Thanks in advance
On the UAV flight simulator, when I disable GPS on the remote everything is fine and GPS switches off. The simulator then flies without GPS....no surprises so far.
However, when I try to re-enable GPS on the remote, the remote already says it is on, but it isn't. The slider seems to be locked in the on position and off is no longer an option.
The only way I have found to fix this is to rebind. The connection is then re-established with GPS active and all is well.
I have a Q5004K using the ST10+. I have posted in general as the issue may also apply to the ST10 or ST16 too.
Question: Am I doing something wrong and there is an easy way to resolve this, or is it just a quirk of the simulation and what I am currently doing is my only option?
FYI: I have switched off GPS when connected my real Q500 and successfully re-enabled it. For clarity though I did this on my kitchen table just to check the option worked; I have never done it when flying.
Thanks in advance