Im having a problem with uav toolbox mission planner, what i do is create a new simple mission, mark my start point, mark point A say 50ft, point B say 100ft, point C say 75ft, go to right lower corner and save the mission under a name, exit out, put the H in a hover, select CCC, tap list and select my mission, slide start, then the H heads out to point A, once at point A it highlights and the H stops and hovers and stays there, if I move the left stick in all directions nothing happens(right stick works fine for the camera), I have to cancel CCC and fly it back, if i go back and view the CCC route i created it only shows point A as saved, anybody want to beat me up on this, sorry but i searched and didnt find the answer