Yaw Motor wiring

[Albathistleman]

Desperately seeking help..
Hello All... I recently went "Tree Trimming" with my Typhoon H. A couple of parts got broken, but nothing irreparable.
HOWEVER... the wires from the camera gimbal were separated from inside the Yaw motor housing. Can anyone direct me to where I can find a schematic to reconnect these wires? They did not disconnect from the hot shoe (slide mount)..
They were disconnected from inside. PLEASE and Thank you!
UPDATE: It's actually the wires from the HOTSHOE to the little black gizmo in the center of the Yaw motor...

 

[Vaklin]

You need to replace this part.
Slip ring CGO3+

 

[Steve Carr]

This is the slide mount plate inside the upper gimbal for the CGO3+. Note the black wire is difficult to see in the photo. These wires are actually going to a slip ring which is not really a motor. If the wires are broken too closely to the slip ring they cannot be repaired and the slip ring must be replaced.