Hello all today I went to a local water falls to get some footage when I got there I went through the steps of set up and calibration that went well I went into pilot mode and hit the launch button to which the drone did and hovered I did note that it was having a hard time figuring it was the wind I proceeded to take the breeze over the gorge and noticed that it was sluggish and was having tough time hovering it was also starting to turn in a circle so I brought it back to where I was and it sped up faster than usual and found a tree then landed beside the gorge almost lost it but didn't went and retrieved it shut it off then back on reconnected and went to go back into pilot mode I noticed that the satellite button was grayed out so I enabled it went into pilot mode and had no problems after that.
I believe what had happened was that the day before I was flying it indoors and when I went to fly out side I didn't set it back to outdoor flying I belie e this is why the drone was acting strange
Just thought I would share this incase someone else has had the same problem this could be the reason why
I believe what had happened was that the day before I was flying it indoors and when I went to fly out side I didn't set it back to outdoor flying I belie e this is why the drone was acting strange
Just thought I would share this incase someone else has had the same problem this could be the reason why