Camera Connection

Vic · Aug 19, 2018

The notice at the top of my ST-16 says "Reconnecting to camera, please wait___" from the time I turn it on until I shut it off. I'm trying to get this stuff to work in my living room before heading out to an open field. Yesterday, after my first trip out of the house with the drone, and a failure at attempting to calibrate the compass I came back in & fumbled around until I was able to calibrate it about six feet from the controller. I know, I know-----I'll recalibrate it outside! Back to the problem---I'm guessing that I'm not getting a wifi connection between the two units. What's up?

Vic

CraigCam · Aug 19, 2018

Do you never get the camera? It’s possibly not bound properly. Do you know where to look for that?

Vic · Sep 17, 2018

CraigCam said:
Do you never get the camera? It’s possibly not bound properly. Do you know where to look for that?

I just noticed your reply---I guess I don't get notified via email when there is a response. I don't believe that the controller & camera are bound. I see that notice now & then. I attempted a calibration today. The camera moved around for 2-3 minutes & then stopped. I got no notice that it had completed nor was calibrated. Also, what am I supposed to do with the login page. Someone said to put in 10 digits & it will work. Not mine!

Vic

Eagle's Eye Video · Sep 17, 2018

Vic · Sep 17, 2018

Eagle's Eye Video said:
To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

I have run this video around 10 times and in no way can I get a blinking yellow light by tilting the H 45 deg. Also, when selecting a camera, there is no C-COG3+ option so I keep getting a "select the right camera" message.

Vic

BobW55 · Sep 17, 2018

Is there any camera listed to select?

Vic · Sep 17, 2018

Yes: C-G03, C-G03-Pro, C-G0ET, & C-G04.

Vic

Eagle's Eye Video · Sep 17, 2018

select CGO3 Pro

CraigCam · Sep 18, 2018

Did you try by setting up new model then binding to that? Or start the H first before St and tilt after start up to get flashing bind light? With no ST on its searching for signal and should go to bind when prompted with the three forward tilts.

Vic · Sep 18, 2018

CraigCam said:
Did you try by setting up new model then binding to that? Or start the H first before St and tilt after start up to get flashing bind light? With no ST on its searching for signal and should go to bind when prompted with the three forward tilts.

The tilt routine does not work. I can get the controller & the drone to bind just fine. Can you help me by just working on getting the camera set up properly so that the wifi will connect? Thanks!

Vic

Vic · Sep 19, 2018

I have no idea what I did just now but the H and the camera are working properly on my living room floor. I shut all systems down and reinitiated them. Both systems binded again so I guess I'm off and running until the next incident. Now, with six new props (after the crash) I'm ready to go flying again.

Vic

AH-1G · Sep 19, 2018

Vic said:
I have no idea what I did just now but the H and the camera are working properly on my living room floor. I shut all systems down and reinitiated them. Both systems binded again so I guess I'm off and running until the next incident. Now, with six new props (after the crash) I'm ready to go flying again.

Vic

Slow down, breath and have a wonderful flight. So don't run.