Camera, controller and antenna swap after a crash - I have both Q500+ 1K and 4K

[River88]

Hi folks….. crashed my Q500 4K..... broken arm. It just would not respond properly when trying to land. Maybe I accidently put it in SMART mode..... but not sure. I was bringing it back because I didn't like how it was performing at 300 feet. If anyone has time here to review the data I could upload it here.

The bigger question I have is how to blend my Q500+ 1K and 4K. So the 4K camera is perfectly good (surprisingly ) and now I have mounted it on my older Q500+ 1K drone. However, I have a Raptor SR 4Hawks antenna mounted on the black ST10+. Which controller should I use for the Q500+ 1K? If I can't use the black ST0+ you think that antenna can be moved to the white ST10 ?

Any tricks needed to bind and ensure the 4K camera works on the 1K drone?

Are the motors the same on the 1K and 4K Q500s ? They both say YUNM4234 KV700.


Appreciate any feed back.

 

[WTFDproject]

The black ST10+ is identical to the white except the color. You just have to create a new model on it for the Q500, and bind both drone and camera to the new model.

 

[River88]

Thank you... that worked perfectly. Up and flying again.