Okay I have a problem. I have 2 wires soldered back on. But the power wire seems to have ripped off the solder connection on the board and I can't get solder to stick to it now. Anyone have any idea how to get it to solder to the board?
This was explained earlier in the thread. The pad that the wire solders to has been ripped out of the board. It's either stuck to the solder on the end of the wire or has been completely ejected, leaving only a pit that cannot accept solder.
Either use the umbilical or jump this stray wire to the pin of the molex connector that the umbilical uses.
That's the cable. It should have come with the drone. I think it's in the Accessories box (long black box with an orange pull tab).
That's the cable. It should have come with the drone. I think it's in the Accessories box (long black box with an orange pull tab).
We use essential cookies to make this site work, and optional cookies to enhance your experience.