CG02 connection with Q500

[Evrybady]

Hello, someone can take a picture of the cg02 where the cables from the drone q500 are to be inserted ??? in PWM??Thanks

 

[WTFDproject]

The PWM /control cable is the two wire cable with a three wire connector on the camera end. (one slot is not used). It goes in the right-hand side of the camera, in any one of the slots marked D, E, or F.
D is normally used, but the other two are the same.

Note: While the three wire connector has two wires physically attached, only one of them actually carries the PWM signal. The other does nothing.

 

[Evrybady]

Thanks