ESC problem

[Chevyfreke]

I replaced the rear ESC with a new one from yuneek. I don't know what is wrong but it is still showing the same ESC is bad any suggestions

 

[WTFDproject]

I don't know what is wrong but it is still showing the same ESC is bad any suggestions

Did you redo the motor assignments in the GUI, or just open the GUI and see the error still present.
The GUI/Q500 sometimes seems to remember ESC errors until they are cleared by re-running the Motor assignments.

 

[Chevyfreke]

Yeah I run the motors and it still shows error

Did you redo the motor assignments in the GUI, or just open the GUI and see the error still present.
The GUI/Q500 sometimes seems to remember ESC errors until they are cleared by re-running the Motor assignments.

 

[WTFDproject]

Yeah I run the motors and it still shows error

Motor test and motor assignment are not the same thing. Did you run the motor ESC assignment sequence, where you spin the motors by hand, one at a time, in the order specified by the GUI? It's important to know, so we have can pursue the right path.

 

[Chevyfreke]

Yeah I did that

Motor test and motor assignment are not the same thing. Did you run the motor ESC assignment sequence, where you spin the motors by hand, one at a time, in the order specified by the GUI? It's important to know, so we have can pursue the right path.

 

[Chevyfreke]

Oh wait not by hand

Motor test and motor assignment are not the same thing. Did you run the motor ESC assignment sequence, where you spin the motors by hand, one at a time, in the order specified by the GUI? It's important to know, so we have can pursue the right path.

 

[Chevyfreke]

Yeah I run the motors and it still shows error

Do I do a few spins on each one or just one spin on each

 

[WTFDproject]

Do I do a few spins on each one or just one spin on each

When each motor is indicated, spin it by hand in the direction indicated. It will usually tell you within a spin or two that it has the code. It will time out after a few seconds if it doesn't see the code.

 

[Chevyfreke]

When each motor is indicated, spin it by hand in the direction indicated. It will usually tell you within a spin or two that it has the code. It will time out after a few seconds if it doesn't see the code.

Ok I'll have to try that when I get home I really appreciate your help thanks

 

[Russell Smith]

Do I do a few spins on each one or just one spin on each

It'll tell you when to go to the next one.

 

[Chevyfreke]

Ok I'll have to try that when I get home I really appreciate your help thanks

That what it was lol. Now I know thanks again WTFD

 

[Chevyfreke]

It'll tell you when to go to the next one.

Thanks Russell

 

[krucialskb]

Hi. I did a tutorial type video on esc replacement. Maybe it can be some help? Yuneec Typhoon G ESC Repair video