Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Power switch broken

Joined
Jul 4, 2016
Messages
7
Reaction score
0
Age
33
20160713_222112.jpg 20160713_222112.jpg 20160713_222112.jpg Had a crash other day..Bought new frame and installed everything from old frame..then saw power switch broken..getting no power even if I put switch back on and sitch to on doesnt want to power on..Any suggestions..picture attached
 
I am sure the switch is bad, did you ohm it out? If bad, I seriously doubt Yuneec will sell just a circuit board switch? But you will probably need to end up buying the whole board? Unless a electronics store carries a replacement! Board should not be too much $$$, if Yuneec will even sell it?:rolleyes:
 
I am sure the switch is bad, did you ohm it out? If bad, I seriously doubt Yuneec will sell just a circuit board switch? But you will probably need to end up buying the whole board? Unless a electronics store carries a replacement! Board should not be too much $$$, if Yuneec will even sell it?:rolleyes:
tengo el mismo problema, se ha destruido el sw de encendido, alguien sabe si se consigue esta parte?
 

New Posts

Members online

Forum statistics

Threads
20,955
Messages
241,593
Members
27,287
Latest member
wccannabis