- Joined
- May 21, 2020
- Messages
- 12
- Reaction score
- 2
- Age
- 52
I apologize if this is in the wrong thread, I am new to this forum.
I have the Q500 4k and had a small crash( drop of about 3 feet. I broke the tips off of two blades, otherwise everything seemed fine, until I got my replacement blades installed and went to fly. The issue is actually with my camera. As soon as the drone is fully powered up, the camera will automatically tunr to the left, and every now and then will flip back and forth unless I physically stop it from doing so. Then it just sits turned to the left. Once I turn the drone off, the camera seems to be freed up and returns to a forward facing position. The same thing happens when I attach the camera to the SteadyGrip. The camera seems fine other than this issue, the up and down controls on the controllers work fine. I have tried to reset the camera using the buttons under the SD card slot, I have unbound and then rebinded the ST10 Controller. Nothing I do seems to work. I would appreciate any help anyone could suggest. With Yuneec US essentially out of business, I have no where else to turn. I love my drone, and have loads of fun flying, but I really need to get this camera issue resolved.
I have the Q500 4k and had a small crash( drop of about 3 feet. I broke the tips off of two blades, otherwise everything seemed fine, until I got my replacement blades installed and went to fly. The issue is actually with my camera. As soon as the drone is fully powered up, the camera will automatically tunr to the left, and every now and then will flip back and forth unless I physically stop it from doing so. Then it just sits turned to the left. Once I turn the drone off, the camera seems to be freed up and returns to a forward facing position. The same thing happens when I attach the camera to the SteadyGrip. The camera seems fine other than this issue, the up and down controls on the controllers work fine. I have tried to reset the camera using the buttons under the SD card slot, I have unbound and then rebinded the ST10 Controller. Nothing I do seems to work. I would appreciate any help anyone could suggest. With Yuneec US essentially out of business, I have no where else to turn. I love my drone, and have loads of fun flying, but I really need to get this camera issue resolved.