Terminal shroud pulling back

[Thomas111]

Ok guys what's your thoughts on this charges up ok holds charge and works as it should but thought I would ask yous guys thoughts on what could cause this

Photo by crawfordracing

Photo by crawfordracing

 

[Steve Carr]

It appears to be poor construction. Is the pin tight or does it move around? If the pin seems tight I would simply add a bit of epoxy to fill the gap.

 

[Thomas111]

Hi Steve yea the pin is tight I have contacted Gifi with pictures as it was only bought this year

 

[Steve Carr]

Good idea. I doubt that it will cause any problems if you are using the stock charger. If you are using an EC3 connector to charge then it may be difficult to seat.

 

[Thomas111]

Am using a ec3 adaptor it was a bit tough to go on hence why I think it did not charge fully although my charger showed all cells full but when came to using the battery once up in the air it went to 10.8 will wait and see what Gifi says