Vibration problems

[Nickannius]

With the firmware updated, has anyone had vibration problems from the gimbal of the e-90 camera?
Do you know of any solution?

Thanks

 

[Steve Carr]

With the firmware updated, has anyone had vibration problems from the gimbal of the e-90 camera?
Do you know of any solution? Thanks

Interesting. So the vibration comes from the camera while sitting on a table? Does it get better or worse if you lightly put your finger on different places on the camera?

 

[NorWiscPilot]

Also, two more things to document:

Does the vibration happen all the time or only when panning?

At all camera tilt angles or just below 30 degrees (or some other value?

I had two cameras that vibrated only when panning, and only when dropped below 30 degrees.

I now have a camera that does not vibrate! (By the way, it is an E50.)

Jeff

 

[Nickannius]

Interesting. So the vibration comes from the camera while sitting on a table? Does it get better or worse if you lightly put your finger on different places on the camera?

Thanks for your interest. Yes, if you touch the camera the vibration stops. Sometimes the vibration occurs when the camera is fixed and the drone rotates or also when you lower the flight drone you notice that the camera is vibrating

 

[Nickannius]

Also, two more things to document:

Does the vibration happen all the time or only when panning?

At all camera tilt angles or just below 30 degrees (or some other value?

I had two cameras that vibrated only when panning, and only when dropped below 30 degrees.

I now have a camera that does not vibrate! (By the way, it is an E50.)

Jeff

Thank you jeff, the vibration occurs regardless of the angle of the camera

 

[NorWiscPilot]

Contact Yuneec. They may offer a fix or replacement.

Suggest using Chat first. Been very responsive and successful.

 

[Steve Carr]

On other cameras with this problem it was just slightly out of balance. I would use Scotch tape to put a tiny washer in different locations on the cam to get it in balance. However, the E90 should balance with the gimbal calibration. If it's in warranty I would suggest contacting Yuneec.

 

[Nickannius]

Contact Yuneec. They may offer a fix or replacement.

Suggest using Chat first. Been very responsive and successful.

Thaks! I've alredy done it!!

 

[Nickannius]

On other cameras with this problem it was just slightly out of balance. I would use Scotch tape to put a tiny washer in different locations on the cam to get it in balance. However, the E90 should balance with the gimbal calibration. If it's in warranty I would suggest contacting Yuneec.

Thanks a lot!

 

[NorWiscPilot]

Nick,

Any news? Did you get a resolution to the vibration issue with your E90?

Jeff

 

[NorWiscPilot]

Thanks a lot!

Nick,

Did you ever get a resolution to your E90 vibration issue?

Jeff

 

[Nickannius]

Nick,

Did you ever get a resolution to your E90 vibration issue?

Jeff

Unfortunately, I still do not have a solution to my problem. I am in contact with the technical service of yuneec so that they give me a solution.

Thanks

 

[Nickannius]

Good morning,

I have solved the problem by changing the dampers. Thanks